PTFE bubble point Membrane polytetrafluoroethylene and its filling products:
1. General materials: various rods, tubes, plates, membranes, belts, ropes, packings, and gaskets.
2. Anti-corrosion 1. Pipes and accessories: pure polytetrafluoroethylene pipe; polytetrafluoroethylene lined pipe; outer fiberglass reinforced plastic pipe; steel composite flange; 2. Chemical container lining: PTFE lined kettle; PTFE lined tank; PTFE lined tower; 3. Heat exchanger; 4. Corrugated telescopic tube; 5. Main components of valves and pumps; 6. Steel wire reinforced full Pressure hose; 7. Filter material.
PTFE Bubble Point Film Polytetrafluoroethylene film has a large number of pores in it after being stretched vertically and horizontally in both directions. It is a new material. By combining it with other fabrics, it can be made into a smoke solid phase anti-corrosion filter bag or a good Waterproof, breathable, windproof and warm rain gear, sportswear, cold-proof clothing, special protective clothing and lightweight tents, compressed air for pharmaceuticals, sterile filtration of various solvents and filtration of high-purity gases in the electronics industry.
3. Seal type 1. Static seal: sandwich gasket; seat belt; elastic sealing belt; 2. Dynamic seal (braided packing, ring seal): V-shaped sealing body is used for shafts, Piston rods, valves; turbine pump internal seals; composite sealing rings of polytetrafluoroethylene and rubber; retractable mechanical seals with bellows.
IV. Load-bearing category 1. Filled polytetrafluoroethylene bearings, used in food, chemical, papermaking, and textile machinery; 2. Porous copper-impregnated fluoroplastic metal bearings, which can be used under high temperature, high pressure, dry friction, and vacuum conditions Normal use; 3. Bearing lining made of composite fabric blended with polytetrafluoroethylene fiber and glass fiber or other fibers for low speed and high load; 4. Filled with polytetrafluoroethylene piston ring, Guide rings, machine tool guide rails and bridge sliders; 5. Insulation categories: 1. Class C insulation materials for wires and cables; 2. Sheaths for stator and rotor water pipes and thermocouples of double water internally cooled turbine generators; 3. High Microwave insulation materials for high-frequency and ultra-high frequency communication equipment and radar; 4. Insulation materials for printed circuit substrates and motors and transformers (including gas transformers); 5. Microwave insulation materials for air conditioners, electronic furnaces, various heaters and sulfur hexafluoride circuit breakers Insulating materials; 6. Anti-sticking: 1. The PTFE glass cloth coating on the hot roller of the sizing machine can avoid the roller sticking phenomenon caused by chemical slurry, greatly improving the production rate and gray cloth quality; 2. Food industry Compared with conveyor belts made of other materials, the microwave drying conveyor belt does not absorb microwave energy, so the non-stick material has the advantages of energy saving and cleaning; 3. PTFE bubble point film polyethylene bag sealing heat sealing sleeve anti-stick material; 4. Anti-stick coatings are used in kitchen pots, bread baking molds, frozen food storage trays, electric iron supports, and copier rollers; 7. Temperature resistance: 1. Microwave oven drive transmission devices, such as microwave oven couplings , rollers; 2. Temperature-resistant accessories for various refrigerators, air conditioners, oxygen concentrators, and compressors; 8. Other categories: 1. Human body substitute arteries, veins, and cardiac membranes; 2. Endoscopes, clamp catheters, and tracheas ; 3. Other medical equipment such as tubes, bottles, filter cloths, etc. </p
